LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Mirror System) >> Diagnostic Information and Procedures >> DTC B1580 or B1590 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X2 harness connector at the appropriate outside rearview mirror.
  2. Wait 1 minute, test for less than 1.0 ohm between the low reference circuit terminal 7 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the appropriate door module.
  3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal 3 and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the appropriate door module.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the door module.
  4. Install a 3A fused jumper wire between the signal circuit terminal 5 and the 5-volt reference circuit terminal 3. Verify the scan tool Mirror Vertical Position parameter is greater than 4.8 volts.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the door module.
  5. Install a 3A fused jumper wire between the signal circuit terminal 6 and the 5-volt reference circuit terminal 3. Verify the scan tool Mirror Horizontal Position parameter is greater than 4.8 volts.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the door module.
  6. Install a 3A fused jumper wire between the signal circuit terminal 5 and the low reference circuit terminal 7. Verify the scan tool Mirror Vertical Position parameter is less than 0.2 volt.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the door module.
  7. Install a 3A fused jumper wire between the signal circuit terminal 6 and the low reference circuit terminal 7. Verify the scan tool Mirror Horizontal Position parameter is less than 0.2 volt.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the door module.
  8. If all circuits test normal, test or replace the outside rearview mirror motor.
scientia non olet · About LEMON Manuals