LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Engine Mechanical - 4.6L (5 Of 5)) >> Repair Instructions - Off Vehicle (3 Of 3) >> Power Steering Pump Installation

Power Steering Pump Installation

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Power Steering Pump Retaining Bolt
    GM71094Courtesy of GENERAL MOTORS CORP.
  1. Place the power steering pump in position in the engine valley. Slide the molded wedge into the retaining feature cast into the cylinder block.
    2. CAUTION: Refer to Fastener Caution .
    NOTE: You MUST push the power steering pump toward the rear of the engine as much as possible before tightening the bolt.
  2. Install the power steering pump bolt and tighten to 50 N.m (37 lb ft).
scientia non olet · About LEMON Manuals