LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Engine Mechanical - 4.6L (5 Of 5)) >> Repair Instructions - Off Vehicle (3 Of 3) >> Engine Flywheel Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply sealant, GM P/N 12346004, (Canadian P/N 10953480), or equivalent, to the engine flywheel bolts.
    2. Fig 1: Identifying 8 Engine Flywheel Mounting Bolts
    GM1480384Courtesy of GENERAL MOTORS CORP.
  2. Place the engine flywheel in position on the crankshaft.
  3. Loosely install a bolt at the top and bottom of the bolt circle allowing the engine flywheel to hang in position.
    4. Fig 2: J 44214 Securing Engine Flywheel
    GM651418Courtesy of GENERAL MOTORS CORP.
  4. Install the J 44214:  holder to the engine block.
  5. Install the remaining engine flywheel bolts.
    6. CAUTION: Refer to Fastener Caution .
  6. Tighten the engine flywheel bolts.
    1. Tighten the engine flywheel retaining bolts to 30 N.m (22 lb ft) .
    2. Tighten the engine flywheel retaining bolts an additional 50 degrees using the J 45059:  meter .
scientia non olet · About LEMON Manuals