LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Engine Mechanical - 4.6L (5 Of 5)) >> Repair Instructions - Off Vehicle (3 Of 3) >> Crankshaft Balancer Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Crankshaft Balancer
    GM350288Courtesy of GENERAL MOTORS CORP.
  1. Position the crankshaft balancer on the nose of the crankshaft.
    2. Fig 2: Identifying J 41998-A Installing Crankshaft Balancer
    GM53637Courtesy of GENERAL MOTORS CORP.
  2. Press the crankshaft balancer in place using the J 41998-B:  installer.
    3. Fig 3: View of Crankshaft Balancer Bolt Threads
    GM350291Courtesy of GENERAL MOTORS CORP.
  3. Clean the crankshaft balancer bolt threads.
  4. Apply engine oil to the crankshaft balancer bolt threads.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the crankshaft balancer bolt.
    1. Tighten the crankshaft balancer bolt to 50 N.m (37 lb ft) .
    2. Tighten the crankshaft balancer bolt an additional 150 degrees using the J 45059:  meter .
    6. Fig 4: J 44214 Securing Engine Flywheel
    GM651418Courtesy of GENERAL MOTORS CORP.
  6. Remove the J 44214:  holder from the engine block.
scientia non olet · About LEMON Manuals