Special Tools
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
J 42385-2000 Thread Insert Kit. See Special Tools .
NOTE:
- In order to repair some crankshaft main bolt holes it will be necessary to mount the fixture plate upside down.
- Do NOT remove the fixture plate prior to installing the insert with the installation driver. The fixture plate remains in position throughout the thread repair process.
The crankshaft main bearing bolt hole thread repair kit J 42385-2000 components consist of the following: See Special Tools .
- Drill (1) J 42385-511
- Tap (2) J 42385-512
- Installation driver (3) J 42385-513
- Fixture plate (4) J 42385-306
- Bushing (5) J 42385-307
- Alignment pin (6) J 42385-308
- Bolts (7) J 42385-510
WARNING:
Refer to Safety Glasses Warning
.
NOTE:
- Ensure the fixture plate is installed during the machining and installation processes of the insert.
- The use of a cutting type fluid GM P/N 1052864, (Canadian P/N 992881), WD 40® or equivalent is recommended when performing the drilling, counterboring and tapping procedures.
When installed to the proper depth, the flange of the insert will be seated against the counterbore of the drilled/tapped hole.