Rear Seat Belt Retractor Replacement
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove the rear seat. Refer to Rear Seat Back Cushion Replacement and Rear Seat Cushion Replacement . |
|
| 1 | Shoulder Belt Anchor Plate Bolt
CAUTION:
Refer to Fastener Caution
.
Tighten: 30 N.m (22 lb ft) |
| 2 | Rear Seat Retractor Bolt Hole Plug Tip: Use a small flat-bladed tool to remove the plug. Use caution to not scratch the finish of the plug or the housing. |
| 3 | Rear Seat Retractor Bolt Tighten: 36 N.m (27 lb ft) |
| 4 | Rear Seat Belt Retractor Nut Tighten: 36 N.m (27 lb ft) |
| 5 | Rear Seat Belt Retractor Assembly |