LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Circuit Malfunction - Passenger >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the seat belt switch.
  2. With the seat belt buckled, test for infinite resistance between the signal circuit terminal A X1 and the low reference terminal B X1.
    • If not the specified range, replace the seat belt switch.
  3. With the seat belt unbuckled, test for less than 2 ohms between the signal circuit terminal A X1 and the low reference terminal B X1.
    • If greater than the specified range, replace the seat belt switch.
scientia non olet · About LEMON Manuals