LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Engine Control System & Fuel System - 4.6L - DTC P0340 To DTC P2433) >> DTC P0442 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize.
  • Refer to the J 41413-200 operation manual for detailed instructions.
  1. Connect the J 41413-200:  EEST to the vehicle at the EVAP service port. For vehicles without a service port, disconnect the purge tube at the quick connector on the EVAP canister side of the purge solenoid valve and install the CH 48096:  Port Tool.
  2. Seal the EVAP system and use the flow meter on the J 41413-200:  EEST, calibrated to 0.51 mm (0.020 in) to determine that there is no leak in the EVAP system.
    • If a leak is detected use the J 41413-200:  EEST to apply smoke to the EVAP system at the service port or the purge tube until the leak is located.
scientia non olet · About LEMON Manuals