Circuit/System Testing
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the TCM X1 connector.
- Measure for 1,260-1,911 ohms between the OSS high signal circuit terminal 41 and the OSS low signal circuit terminal 16.
- If greater than the specified range test the OSS high signal and the OSS low signal circuits for an open/high resistance. If the circuits/connections test normal, replace the input shaft speed sensor.
- If less than 820 ohms test the OSS high signal and the OSS low signal circuits for a shorted together condition. If the circuits/connections test normal, replace the input shaft speed sensor.
- Measure for more than 10 ohms of resistance between the OSS high signal circuit terminal 41 and ground.
- If less than the specified range, repair the short to ground.
- Measure for more than 10 ohms of resistance between the OSS low signal circuit terminal 16 and ground.
- If less than the specified range, repair the short to ground.
- Connect the TCM connector. Disconnect the transmission 20-way connector.
- Ignition ON, test the OSS high signal circuit terminal 41 for a short to voltage.
- If all circuits test normal, test or replace the internal transmission wiring harness or the OSS sensor.