LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Suspension Control System - Suspension Damping) >> Repair Instructions >> Electronic Suspension Front Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ball Stud
    GM575135Courtesy of GENERAL MOTORS CORP.
  1. Insert head of the sensor mounting stud into the key hole.
    2. CAUTION: Refer to Fastener Caution .
  2. Tighten the sensor mounting nut.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  3. Connect the sensor link on the ball stud (1).
  4. Connect the height sensor connector.
  5. Install the wheel on the vehicle. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
scientia non olet · About LEMON Manuals