LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Power Steering System) >> Repair Instructions >> Steering Gear Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Steering Rack
    GM293350Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering gear heat shield.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the power steering gear heat shield mounting bolts.

    Tighten:  Tighten the power steering gear heat shield mounting bolts to 9 N.m (79 lb in).

  3. Install the electrical harness clip to the power steering gear heat shield.
  4. Rotate the stabilizer shaft into position.
  5. Install the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement (FE1 and FE3) or Stabilizer Shaft Link Replacement (FE7) .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals