Removal Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Remove the outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .

Fig 1: Identifying Inner Tie Rod Assembly Jam Nut

Courtesy of GENERAL MOTORS CORP.

Remove the hex jam nut (2) from the inner tie rod.

Fig 2: Removing/Installing Tie Rod End Clamp At Rack & Pinion Boot

Courtesy of GENERAL MOTORS CORP.

Remove the tie rod end clamp (2) from the rack and pinion boot (1).
Remove the rack and pinion boot clamp from the rack and pinion boot.

Fig 3: Removing Rack & Pinion Boot

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: After removing the boot, inspect the inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear.

Remove the rack and pinion boot (1) from the steering gear.