LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Power Steering System) >> Repair Instructions >> Power Steering Pump Pulley Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Secondary AIR Relay Bracket & Nuts
    GM518257Courtesy of GENERAL MOTORS CORP.
  1. Remove the secondary AIR relay bracket retaining nuts (2).
  2. Remove the secondary AIR relay bracket (1) from the mounting studs.
    3. Fig 2: View Of Surge Tank, Nuts & Screw
    GM517960Courtesy of GENERAL MOTORS CORP.
  3. Remove the surge tank retaining nut (2) and bolt (3).
  4. Position and support the surge tank out of the way.
    5. Fig 3: View Of Power Steering Pump Pulley Remover
    GM649303Courtesy of GENERAL MOTORS CORP.
  5. Remove the drive belt. Refer to Drive Belt Replacement .
  6. Using J 25034-C  remove the power steering pump pulley. See Special Tools .
scientia non olet · About LEMON Manuals