LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Right Side (JL9) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Park Brake Cable & Caliper
    GM1665547Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake cable (1) into the bracket on the brake caliper (3).
  2. Slide the park brake cable forward and install to the park brake actuator lever (2).
    3. Fig 2: Identifying Retaining Bolts & Retaining Clip
    GM1665546Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the 2 retaining bolts (1).

    Tighten:  Tighten the retaining bolts to 6 N.m (53 lb in).

  4. Install the retaining clip (2).
    5. Fig 3: Removing/Installing Rear Park Brake Cable
    GM1665553Courtesy of GENERAL MOTORS CORP.
  5. Install the left park brake cable (2) to the equalizer (1).
    6. Fig 4: Removing/Installing Front Park Brake Cable
    GM1665542Courtesy of GENERAL MOTORS CORP.
  6. Install the right rear brake cable (4) to the equalizer (3).
  7. Install the front brake cable (1) in the connector (2).
  8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
scientia non olet · About LEMON Manuals