LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Left Side (JL9) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Park Brake Cable & Caliper
    GM1665547Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake cable (1) into the bracket on the brake caliper (3).
  2. Slide the park brake cable forward and install to the park brake actuator lever (2).
    3. Fig 2: Locating Cable Retaining Bolt
    GM1665554Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the retaining bolt (2).

    Tighten:  Tighten the retaining bolt to 6 N.m (53 lb in).

  4. Install the retaining clip (1).
    5. Fig 3: Identifying Left Rear Brake Cable In The Retainer
    GM1665551Courtesy of GENERAL MOTORS CORP.
  5. Install the left rear brake cable in the retainer (1).
    6. Fig 4: Removing/Installing Left Park Brake Cable
    GM1665552Courtesy of GENERAL MOTORS CORP.
  6. Install the left rear brake cable (1) in the retaining bracket (2).
    7. Fig 5: Removing/Installing Rear Park Brake Cable
    GM1665553Courtesy of GENERAL MOTORS CORP.
  7. Install the left rear brake cable (3) to the equalizer (1).
    8. Fig 6: Removing/Installing Front Park Brake Cable
    GM1665542Courtesy of GENERAL MOTORS CORP.
  8. Install the front brake cable (1) in the connector (2).
  9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
scientia non olet · About LEMON Manuals