Installation Procedure
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connectors to the park brake warning light switch.
- Install the park brake pedal assembly into the vehicle.
- Install the park brake pedal assembly mounting nuts (1, 2) to the vehicle.
Tighten: Tighten the park brake pedal assembly mounting nuts to 24 N.m (18 lb ft).
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Reconnect the front park brake cable (3) to the cable connector (1).
- Lower the vehicle.
- If installing a new park brake pedal assembly, you must remove the park brake pedal and cable set pin (1).
- To set the park brake cable tension rotate the tension release pin (1) 80 degrees and then pull down to remove.
- Apply the park brake pedal 3 full cycles to complete the tension set.
- Install the left knee bolster. Refer to Driver Knee Bolster Replacement .
- Install the left closeout/insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
- Install the left carpet retainer. Refer to Front Side Door Opening Floor Carpet Retainer Replacement .
CAUTION:
Refer to Fastener Caution
.