LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Hydraulic Brake System) >> Repair Instructions >> Master Cylinder Reservoir Replacement (J55) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the master cylinder reservoir for cracks or deformities. If found, replace the reservoir.
  2. Clean the reservoir with clean denatures alcohol or equivalent.
  3. Dry the master cylinder reservoir with non-lubricated, filtered air.
    4. Fig 1: View Of Master Cylinder Reservoir & Seals
    GM153127Courtesy of GENERAL MOTORS CORP.
  4. Lubricate the new seals and the reservoir bayonets with GM approved brake fluid from a clean, sealed brake fluid container. Refer to Fluid and Lubricant Recommendations .
  5. Install the seals, making sure they are fully seated.
  6. Install the reservoir onto the master cylinder by pressing straight down by hand until the pins holes are aligned.
  7. Press straight down by hand until pin holes are aligned.
    8. Fig 2: View Of Reservoir Retaining Pins & Hammer
    GM176838Courtesy of GENERAL MOTORS CORP.
  8. Carefully tap in the master cylinder reservoir retaining pins to secure the reservoir.
  9. Fill the master cylinder reservoir. Refer to Master Cylinder Reservoir Filling .
  10. Install the master cylinder fluid level sensor. Refer to Brake Fluid Level Indicator Switch Replacement .
  11. Connect the electrical connector to fluid sensor.
  12. Install the master cylinder. Refer to Master Cylinder Replacement .
scientia non olet · About LEMON Manuals