LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Power Seat System) >> Repair Instructions >> Front Seat Recliner Position Sensor Replacement

Front Seat Recliner Position Sensor Replacement

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Front Seat Recliner Position Sensor
GM1596339Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedure

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the front seats. Refer to Driver or Passenger Seat Replacement .
  3. Remove the seat back cushion finish panel. Refer to Driver or Passenger Seat Back Cushion Finish Panel Replacement .
  4. Remove the head restraint. Refer to Driver or Passenger Seat Head Restraint Replacement .
  5. Remove the head restraint guides. Refer to Front Seat Head Restraint Guide Replacement .
  6. Remove the inflatable restraint front seat side module. Refer to Driver or Passenger Seat Side Inflatable Restraint Module Replacement .
  7. Remove the seat back cushion cover and pad. Refer to Driver or Passenger Seat Back Cushion Cover and Pad Replacement .
  8. Remove the seat back side outer cover.
  9. Remove the seat back side inner cover.
1 Seat Recliner Position Sensor
Tip: 
  • Remove the pivot rod retainer. Do not reuse retainer.
  • Slide out the seat pivot rod out of the seat position sensor and recliner motor.
scientia non olet · About LEMON Manuals