LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Power Seat System) >> Diagnostic Information and Procedures >> Power Seat Inoperative (Without Memory A45) >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the seat adjuster switch.
  2. Test for infinite resistance between the B+ terminal and each control terminal with the switch in the open position.
    • If less than the specified value, replace the seat adjuster switch.
  3. Test for less than 1 ohm between the B+ terminal and each control terminal with the switch in the closed position.
    • If greater than the specified range, replace the seat adjuster switch.
  4. Test for less than 1 ohm between the ground terminal and each control terminal with the switch in the open position.
    • If greater than the specified range, replace the seat adjuster switch.