LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Sunroof System) >> Repair Instructions >> Sunroof Window Height and Opening Fit Adjustment

Sunroof Window Height and Opening Fit Adjustment

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Cycle the sunroof window from the full open to closed position.
    2. Fig 1: Identifying Sunroof, Housing And Adjusting Screws
    GM468350Courtesy of GENERAL MOTORS CORP.
  2. Loosen the 4 adjusting screws (1).
  3. There are 2 adjusting screws on each side of the sunroof window.
  4. Center the window front to rear in the opening.
    5. Fig 2: Adjustment Of Front Of Sunroof Window Below Top Surface Of Roof Panel
    GM468352Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  5. Adjust the front of the sunroof window (2) from flush to 1 mm (0.04 in) (1) below the top surface of the roof panel (3).

    Tighten:  Tighten the front sunroof window adjustment screws to 5 N.m (44 lb in).

    6. Fig 3: Adjustment of Rear Sunroof Window Below Top Surface of Roof Panel
    GM468351Courtesy of GENERAL MOTORS CORP.
  6. Adjust the rear of the sunroof window (2) from flush to 1 mm (0.04 in) (1) above the top surface of the roof panel (3).

    Tighten:  Tighten the rear sunroof window adjustment screws to 5 N.m (44 lb in).

  7. Cycle the sunroof window through all of the positions.
  8. Verify the sunroof window fore/aft adjustments.
  9. Verify the front and rear height adjustment.
  10. Readjust the sunroof window, if necessary.
scientia non olet · About LEMON Manuals