LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Sunroof System) >> Diagnostic Information and Procedures >> Power Sunroof Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the sunroof switch.
  2. Test for infinite resistance between the sunroof switch terminals listed below and the ground circuit terminal 5 with the switch in the open position.
    • Vent express terminal 1
    • Sunroof close terminal 2
    • Vent open terminal 4
    • Vent close terminal 6
    • Sunroof express terminal 7
    • Sunroof roof open terminal 8
    • If less than the specified range, replace the sunroof switch.
  3. NOTE: If the switch tests open in any switch position other than Off, test the sunroof switch signal circuits for a short to voltage before replacing the switch.
  4. Test for less than 3 Ω between the sunroof switch terminals listed below and the ground circuit terminal 5 and with the switch in the appropriate position.
    • Vent express terminal 1
    • Sunroof close terminal 2
    • Vent open terminal 4
    • Vent close terminal 6
    • Sunroof express terminal 7
    • Sunroof roof open terminal 8
    • If greater than the specified range, replace the sunroof switch.