Component Testing
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Rear Heated Seat Switch
- Ignition OFF, disconnect the harness connector at the heated seat switch switch.
- Test for infinite resistance between the signal terminal G and the ground terminal J with the seat back and cushion switch in the open position.
- If not the specified value, replace the heated seat switch switch.
- Test for infinite resistance between the signal terminal A and the ground terminal J with the seat back only switch in the open position.
- If not the specified value, replace the heated seat switch switch.
- Test for less than 5 ohms between the signal terminal G and the ground terminal J with the seat back and cushion switch in the closed position.
- If greater than the specified range, replace the heated seat switch.
- Test for less than 5 ohms between the signal terminal A and the ground terminal J with the seat back only switch in the closed position.
- If greater than the specified range, replace the heated seat switch.
- Connect a 3A fused jumper wire between the B+ terminal K and battery voltage.
- Connect a test lamp between the following indicator control circuits and ground. The selected indicator should illuminate.
- Seat back only mode indicator terminal B
- Low heat indicator terminal C
- Medium heat indicator terminal D
- High heat indicator terminal E
- Seat back cushion mode indicator terminal H
- If any indicator does not illuminate, replace the rear heated seat switch.