Circuit/System Description

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Ground is provided to the headlamp switch through the switch ground circuit and G304. With the headlamp switch in the ON position, the headlamps ON signal circuit from the body control module (BCM) is pulled low indicating the headlamps ON request. In response to this signal, the BCM will energize either the high or low beam relay illuminating the headlamps. At the same time when the high beam headlamps are ON, the BCM sends a message via serial data to the instrument panel cluster (IPC) requesting the IPC to illuminate the high beam indicator. Anytime the headlamps are ON and the ignition is OFF or the driver door is opened, the BCM will also request the IPC to turn on the LIGHTS ON INDICATOR located in the driver information center (DIC).