Inflatable Restraint Seat Position Sensor Replacement

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Inflatable Restraint Seat Position Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedures Disable the SIR system. Refer to SIR Disabling and Enabling . Remove the front passenger seat. Refer to Driver or Passenger Seat Replacement . Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .
1	Inflatable Restraint Front Passenger Position Sensor Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten: 3 N.m (25 lb in)
2	Inflatable Restraint Front Passenger Position Sensor Assembly Tip: Disconnect the electrical connector.

Callout

Component Name

WARNING: Refer to SIR Warning .

Preliminary Procedures

Disable the SIR system. Refer to SIR Disabling and Enabling .
Remove the front passenger seat. Refer to Driver or Passenger Seat Replacement .
Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .

Inflatable Restraint Front Passenger Position Sensor Screw (Qty: 2)

CAUTION: Refer to Fastener Caution .

Tighten: 3 N.m (25 lb in)

Inflatable Restraint Front Passenger Position Sensor Assembly
Tip: Disconnect the electrical connector.