Windshield Washer Solvent Container Replacement

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Washer Solvent Container Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the right front wheelhouse panel liner. Refer to Front Wheelhouse Liner Replacement . Drain the washer solvent into a suitable clean container. Disconnect the electrical connector from the windshield washer solvent level sensor. Disconnect the electrical connector at the windshield washer pump.
1	Windshield Washer Level Sensor Switch
2	Windshield Washer Pump Hose Assembly Tip: Disconnect the hose from the windshield washer pump spout and drain washer solvent into a suitable clean container.
3	Windshield Washer Solvent Container Nut (Qty: 2) CAUTION: Refer to Fastener Caution . Tip: Transfer the level sensor and washer pump to the new washer solvent container. Tighten: 6 N.m (53 lb in)
4	Windshield Washer Container Assembly Tip: Lower the windshield washer container from RH chassis rail.