LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Windshield Washer Solvent Heater Malfunction >> Circuit/System Testing >> Windshield Heated Washer Fluid Indicator Inoperative

Windshield Heated Washer Fluid Indicator Inoperative

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X2 harness connector at the windshield washer solvent heater assembly.
  2. Ignition ON, install a 3A fused jumper wire between the heated washer fluid indicator control circuit terminal 2 and ground. Verify the DIC displays the HEATING WASH FLUID WASH WIPES PENDING message.
    • If the message is not displayed, test the control circuit for a short to voltage or open/high resistance. If the circuit tests normal, replace the instrument panel cluster (IPM).
  3. If all circuits test normal, replace the windshield washer solvent heater assembly.
scientia non olet · About LEMON Manuals