LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Washer Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the scan tool Windshield Washer Switch parameter while pressing and releasing the washer switch. The reading should change between Active and Inactive.
    • If the reading does not change between the specified values, refer to the Windshield Washer Switch Circuit Test.
  2. Connect a test lamp between the relay side of the WSW MTR fuse and ground.
  3. Ignition ON, verify that the test lamp turns ON and OFF while pressing and releasing the windshield washer switch.
    • If the test lamp does not turn ON and OFF while changing between the commanded states, refer to the Windshield Washer Pump Relay Control Circuit Test.
  4. If the washer pump does not operate, refer to the Windshield Washer Pump Circuit Test.
scientia non olet · About LEMON Manuals