LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Underhood Electrical Center or Junction Block Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Center
    GM1587969Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install fasteners (2) securing the electrical center to vehicle.

    Tighten:  Tighten the fasteners to 10 N.m (86 lb in).

  2. Install the harness (1).
    3. Fig 2: Electrical Center Board
    GM1587964Courtesy of GENERAL MOTORS CORP.
  3. Install the fasteners (1) securing the electrical center board (2).

    Tighten:  Tighten the fasteners to 7 N.m (62 lb in).

  4. Connect the positive battery cable. Refer to Battery Positive Cable Replacement .
    5. Fig 3: Electrical Center Cover
    GM1587955Courtesy of GENERAL MOTORS CORP.
  5. Install the electrical center cover (1).
scientia non olet · About LEMON Manuals