Ignition and Start Switch Replacement

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Ignition and Start Switch Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the theft deterrent module. Refer to Theft Deterrent Module Replacement .
1	Ignition and Start Switch Bolt CAUTION: Refer to Fastener Caution . Tighten: 1.5 N.m (13 lb in)
2	Steering Wheel Theft Deterrent Lock Tip: The steering wheel theft deterrent lock is not present on vehicles with AN3.
3	Ignition and Start Switch Bolt Tighten: 1.5 N.m (13 lb in)
4	Ignition and Start Switch Procedure Disconnect any electrical connectors as needed. Disconnect the key in ignition switch from the ignition lock cylinder case.