Installation Procedure
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the surface of the brake rotor. Refer to Brake Rotor Surface and Wear Inspection (JL9) or Brake Rotor Surface and Wear Inspection (J55) .
Replace the brake rotor if refinishing is indicated.
- Inspect the disc brake mounting hardware. Refer to Front Disc Brake Mounting and Hardware Inspection .
- Inspect the brake caliper. Refer to Brake Caliper Inspection .
- Install the brake pad retainers into the brake caliper bracket.
- Pivot the brake caliper down over the brake pads and into the brake caliper bracket.
- Apply a thin coat of high temperature silicone brake lubricant to the brake caliper pin bolts.
- Insert the lower brake caliper pin bolt (1) and tighten to 113 N.m (83 lb ft).
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
- Slowly release the brake pedal.
- Wait 15 seconds, then repeat steps 9-10 until a firm brake pedal apply is obtained. This will properly seat the brake caliper pistons and brake pads.
- Fill the brake master cylinder reservoir to the proper level. Refer to Master Cylinder Reservoir Filling .
- Burnish the pads and rotors. Refer to Brake Pad and Rotor Burnishing .
NOTE:
The brake rotor is coated with a corrosion inhibitor and must not be refinished.
CAUTION:
Refer to Fastener Caution
.