LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (FE7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Stabilizer Shaft & Insulators
    GM105022Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft.
  2. Install the stabilizer shaft insulators to the stabilizer shaft with the slit facing forward.
  3. Bend the stabilizer shaft bracket downward to close around the stabilizer shaft insulator.
    4. CAUTION: Refer to Fastener Caution .
    NOTE: Ensure the stabilizer shaft is centered before installing the bracket bolts.
  4. Install the stabilizer shaft bracket bolts

    Tighten:  Tighten the stabilizer shaft bracket bolts to 51 N.m (38 lb ft).

  5. Install the stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement (FE7)  or Stabilizer Shaft Link Replacement (FE1 and FE3) .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals