LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement (FE1 and FE3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft Link Insulators, Spacer, Nut & Bolt
    GM561499Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the stabilizer shaft link insulators, spacer, nut and bolt.

    Tighten:  Tighten the stabilizer shaft link nut to 15 N.m (11 lb ft).

  2. Lower the vehicle.
scientia non olet · About LEMON Manuals