LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (FE7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Stabilizer Shaft & Insulators
    GM105022Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft insulator to the stabilizer shaft with the slit facing forward.
  2. Bend the stabilizer shaft bracket downward to close around the insulator. Ensure the stabilizer bar insulators nest in the clamps. If not, replace the clamps.
    3. CAUTION: Refer to Fastener Caution .
    NOTE: Ensure the stabilizer shaft is centered before installing the bracket bolts.
  3. Install the stabilizer shaft bracket bolt.

    Tighten:  Tighten the stabilizer shaft bracket bolt to 51 N.m (38 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals