Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Rear Body Mount

Courtesy of GENERAL MOTORS CORP.

Install the rear body mount.

CAUTION: Refer to Fastener Caution .

Install the bolts securing the body mount.
Tighten: Tighten the bolts to 77 N.m (57 lb ft).

Fig 2: View Of Rear Suspension And Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Raise the support assembly.
Install the two rear bolts securing the support assembly to the vehicle body.
Tighten: Tighten the bolts to 207 N.m (153 lb ft).

Fig 3: View Of Center Support Brackets

Courtesy of GENERAL MOTORS CORP.

Install the center support bracket bolts (1).
Tighten: Tighten the center support bracket bolts to 128 N.m (94 lb ft).

Fig 4: View of Exhaust Hangers

Courtesy of GENERAL MOTORS CORP.

Refer to Exhaust System Replacement .
Install the tires and the wheels. Refer to Tire and Wheel Removal and Installation .
Tighten: Tighten the wheel nuts to 125 N.m (80 lb ft).
Lower the vehicle.
Inspect and adjust the rear toe. Refer to Rear Toe Adjustment (FE7) or Rear Toe Adjustment (FE1, FE3) .