LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Engine Exhaust System) >> Repair Instructions >> Catalytic Converter Heat Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: In order to avoid being burned, do not service the exhaust system while it is still hot. Service the system when it is cool.
WARNING: Always wear protective goggles and gloves when removing exhaust parts as falling rust and sharp edges from worn exhaust components could result in serious personal injury.
    Fig 1: View Of Catalytic Converter Heat Shield
    GM1670478Courtesy of GENERAL MOTORS CORP.
    WARNING: Eye protection must be worn when drilling rivets to reduce the chance of personal injury.
  1. Remove the exhaust system. Refer to Exhaust System Replacement .
  2. Drill out the heat shield rivets (2).
  3. Remove the heat shield.
scientia non olet · About LEMON Manuals