LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Engine Control System & Fuel System - 4.6L - Introduction (1 Of 2)) >> Repair Instructions >> Ignition Coil Replacement - Bank 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Harness Electrical Connectors
    GM1662120Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. If servicing the ignition coil assembly, perform the following steps, if servicing an individual ignition coil proceed to step 7.
  3. Disconnect the engine harness electrical connector (3) from the ignition coil assembly.
    4. Fig 2: Identifying Ignition Coil Assembly Bolts
    GM1672635Courtesy of GENERAL MOTORS CORP.
  4. Remove the ignition coil assembly bolts.
  5. Remove the ignition coil assembly.
    6. Fig 3: Identifying Ignition Coil
    GM1672556Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the individual ignition coil electrical connector (3), as required.
  7. Remove the individual ignition coil bolt (1), as required.
  8. Remove the ignition coil (2), as required.
scientia non olet · About LEMON Manuals