LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Engine Control System & Fuel System - 4.6L - Introduction (1 Of 2)) >> Repair Instructions >> Fuel Level Sensor Wiring Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Tank Electrical Harness Connectors
    GM1671759Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Disconnect the fuel level sensor wiring harness electrical connectors from the pressure sensor and module.
  3. Remove the fuel level sensor wiring harness.
scientia non olet · About LEMON Manuals