LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Engine Control System & Fuel System - 4.6L - Introduction (1 Of 2)) >> Repair Instructions >> Exhaust Gas Recirculation Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying EGR Valve Inlet Pipe
    GM1666841Courtesy of GENERAL MOTORS CORP.
  1. Position the EGR valve pipe to the exhaust manifold.
    2. CAUTION: Refer to Fastener Caution .
  2. Tighten the EGR pipe nut at the exhaust manifold.

    Tighten:  Tighten the nut to 60 N.m (44 lb ft).

  3. Lower the vehicle.
  4. Install the EGR valve pipe bolt at the water pump housing.

    Tighten:  Tighten the bolt to 28 N.m (21 lb ft).

scientia non olet · About LEMON Manuals