LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Antilock Brake System) >> Repair Instructions >> Rear Wheel Speed Sensor Ring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Speed Sensor & Connector
    GM631238Courtesy of GENERAL MOTORS CORP.
  1. Remove the wheel speed sensor (2). Refer to Rear Wheel Bearing and Hub Replacement (FE7) or Rear Wheel Bearing and Hub Replacement (FE1, FE3) .
    2. Fig 2: View Of Wheel Speed Sensor Reluctor
    GM631451Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not reuse the wheel speed sensor reluctor after it has been removed.
  2. Remove and discard the wheel speed sensor reluctor (1).
scientia non olet · About LEMON Manuals