LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Front Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Wheel Stud
    GM161272Courtesy of GENERAL MOTORS CORP.
  1. Install a new wheel stud.
  2. Using washers and a wheel nut, pull the wheel stud in position.
  3. Install the brake rotor. Refer to Front Brake Rotor Replacement (J55) or Front Brake Rotor Replacement (JL9) .
  4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals