LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Front Suspension System) >> Repair Instructions >> Strut Assembly Replacement (FE7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Upper Strut Mounting Bolts
    GM402795Courtesy of GENERAL MOTORS CORP.
  1. Install the strut.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the 3 strut tower bolts and washers.

    Tighten:  Tighten 3 strut tower bolts to 66 N.m (49 lb ft).

    3. Fig 2: View Of Strut To Knuckle Attaching Nuts & Bolts
    GM474722Courtesy of GENERAL MOTORS CORP.
  3. Install the strut to knuckle bolts and nuts.

    Tighten:  Tighten the strut to knuckle bolts and nuts to 177 N.m (131 lb ft).

  4. Install the brake line bracket to strut.

    Tighten:  Tighten the brake line bracket to 23 N.m (17 lb ft).

    5. Fig 3: Disconnecting/Reconnecting Wheel Speed Sensor Electrical Connector
    GM105002Courtesy of GENERAL MOTORS CORP.
  5. Install the wheel speed sensor bracket to dust shield.
  6. Connect the wheel speed sensor connector.
  7. Install the wheel and tire. Refer to Tire and Wheel Removal and Installation .

    Tighten:  Tighten the wheel and tire to 125 N.m (80 lb ft).

  8. Lower the vehicle.
scientia non olet · About LEMON Manuals