LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (FE7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft Brackets & Bolts
    GM474720Courtesy of GENERAL MOTORS CORP.
  1. Using a pry bar, pry upwards and install the stabilizer shaft insulator to the stabilizer shaft.
  2. Install the stabilizer shaft insulator bracket to the stabilizer shaft insulator.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the stabilizer shaft bracket retaining bolts.

    Tighten:  Tighten the stabilizer shaft bracket retaining bolts to 50 N.m (37 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals