Front Wheel Bearing and Hub Replacement (FE1, FE3)

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Wheel Bearing/Hub Replacement - Front (FE1, FE3)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation . Remove the brake rotor from the wheel hub/bearing. Refer to Front Brake Rotor Replacement (J55) or Front Brake Rotor Replacement (JL9) . Special Tools: J 28733-B Front/Rear Spindle Remover
1	Wheel Drive Shaft Nut CAUTION: Refer to Fastener Caution . Tip: Use a suitable tool to prevent the wheel hub/bearing from rotating while removing the axle nut. Tighten: 160 N.m (118 lb ft)
2	Wheel Bearing/Hub Bolt (Qty: 3) Tip: Disconnect the wheel speed electrical connector. Tighten: 130 N.m (96 lb ft)
3	Wheel Bearing/Hub Tip: Use the J 28733-B to press the axle shaft from the wheel/bearing/hub.
4	Dust Shield Tip: Keep the dust shield in position while replacing the wheel bearing/hub.