LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Floor Coverings & Headliners) >> Repair Instructions >> Cardboard Insulator Headliner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:
    • Installation of a new cardboard roof insulator is necessary to ensure the structural integrity of the roof system. Use GM P/N 12378192 Adhesive available through General Motors Service Parts Operations.
    • The cardboard roof insulator must be installed within five minutes of adhesive application.
    Fig 1: Identifying Specified Height & Width Of Adhesive
    GM107685Courtesy of GENERAL MOTORS CORP.
  1. Apply beads of adhesive to a height (2) of 6-9 mm (1/4-3/8 in) and a width 1) of 15 mm (5/8 in).
    2. Fig 2: Applying Adhesive To Locations Marked On Cardboard Insulator
    GM107686Courtesy of GENERAL MOTORS CORP.
  2. Apply the adhesive (1) in the locations marked on the cardboard insulator.
    3. Fig 3: View Of Cardboard Roof Insulator
    GM474278Courtesy of GENERAL MOTORS CORP.
  3. Place the cardboard roof insulator to the roof panel.
    4. NOTE: Gluing the headliner to the cardboard roof insulator during installation is not required.
  4. Install the headliner. Refer to Headlining Trim Panel Replacement (Without PLA)  or Headlining Trim Panel Replacement (With PLA) .
scientia non olet · About LEMON Manuals