LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Mechanical - 4.6L (2 Of 5)) >> Repair Instructions - On Vehicle (1 Of 2) >> Oil Level Indicator Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Oil Level Indicator Tube
    GM1662566Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the oil level indicator tube O-ring seal with clean engine oil.
  2. Install the oil level indictor tube into the lower crankcase opening.
    3. CAUTION: Refer to Fastener Caution .
  3. Slide the indicator tube behind the tube nut. Tighten the nut.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  4. Install the oil level indicator.
  5. Install the front engine mount bracket. Refer to Engine Front Mount Bracket Replacement .
scientia non olet · About LEMON Manuals