LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Mechanical - 4.6L (2 Of 5)) >> Repair Instructions - On Vehicle (1 Of 2) >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Engine Oil Pressure Switch & Electrical Connector
    GM481563Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the engine oil pressure switch (1) to the oil filter adapter (3).

    Tighten:  Tighten the engine oil pressure switch to 16 N.m (12 lb ft).

  2. Install the oil filter adapter. Refer to Oil Filter Adapter Replacement .
  3. Lower the vehicle.
  4. Adjust the engine oil level to the full mark.
  5. Inspect for oil leaks after engine start up.
scientia non olet · About LEMON Manuals