Replacement Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Transmission Mount & Components

Courtesy of GENERAL MOTORS COMPANY

Engine Mount Replacement - Right Side

Callout	Component Name
Preliminary Procedures Raise the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation . Support the transaxle with a suitable stand.
1	Lower Engine Mount Nut CAUTION: Refer to Fastener Caution . Tighten 80 N.m (59 lb ft)
2	Upper Engine Mount Nut Tighten 80 N.m (59 lb ft)
3	Engine Mount Bracket to Engine Stud Tighten 73 N.m (54 lb ft)
4	Engine Mount Bracket to Transaxle Bolt (Qty: 2) Tighten 73 N.m (54 lb ft)
5	Engine Mount Bracket
6	Engine Mount