LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Mechanical - 4.6L (2 Of 5)) >> Repair Instructions - On Vehicle (1 Of 2) >> Engine Mount Bracket Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Right Engine Mount Bracket
    GM1660851Courtesy of GENERAL MOTORS CORP.
  1. Position the right engine mount bracket to the correct holes in the engine block and transaxle.
  2. Install the right engine mount bracket to transaxle bolts finger tight.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the right engine mount bracket to engine stud.

    Tighten:  Tighten the bolts/stud to 73 N.m (54 lb ft).

  4. Install the right engine mount. Refer to Engine Mount Replacement - Right Side .
scientia non olet · About LEMON Manuals