LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Mechanical - 4.6L (2 Of 5)) >> Repair Instructions - On Vehicle (1 Of 2) >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Drive Belt Idler Pulley
    GM1660277Courtesy of GENERAL MOTORS CORP.
  1. Position the drive belt idler pulley to the engine and finger starter the pulley bolt.
    2. CAUTION: Refer to Fastener Caution .
  2. Tighten the drive belt idler pulley bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
scientia non olet · About LEMON Manuals