LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> DTC P0562 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Engine running measure and record the voltage at the battery terminals. Verify that the battery voltage is 12.6-15.5 volts.
  2. Observe the scan tool ECM Ignition 1 Signal parameter. The reading should be between 12.6 and 15.0 volts.
scientia non olet · About LEMON Manuals